Hardwood Flooring in Mableton, GA
Blending new hardwood boards into existing floors for Mableton open concept remodels of mid century ranch homes. Seamless transitions where walls come out. Free quotes.

Mableton, GA Service Area
Mableton sits about 12 miles from our Powder Springs base in Cobb County, and it is in the middle of a transformation. Mableton became a city in 2023, and one of the most common flooring calls we get here is for open concept remodels of mid century ranch homes. When a wall comes out to open up a kitchen or a living area, the two floors that used to be separate rooms have to become one, and that is a custom blending job.
The Mable House, which dates to 1843, is a reminder of how deep the history runs here, and the mid century ranch homes built across Mableton in the decades after have their own character. Those homes often have good original hardwood, and the open concept remodels that are so popular now are a chance to make that original wood the connective tissue of the whole home, if the blending is done right.
When a Wall Comes Out, Two Floors Become One
Take out the wall between a kitchen and a living room and you have a single space where two floors have to read as one. If the two floors are the same species and were installed at the same time, the blend is about matching the finish and the stain so the old and new sections do not look different. If the two floors are different species, different ages, or different cuts, the blending is harder, and the craft shows.
The challenge is that the existing floor has decades of finish and wear on it, while the new boards are raw wood. Even with the same species, a fresh finish on new boards can look different next to an old floor refinished at the same time. We plan for that, testing finishes and stains so the two sections come together as one continuous surface.
Blending New Boards Into an Existing Floor
The actual blending starts with weaving the new boards into the existing field. We do not just drop a rectangular patch of new boards into the gap where the wall was. We cut back the existing floor so the new boards can be staggered into the field, which breaks up the seam and makes the transition read as natural variation rather than a line across the floor.
We match the species, the cut, the width, and the grade as closely as possible, because a board that is too clean or too wide stands out against an older floor. After the boards are laced in, the whole area is sanded and finished together so the new wood and the old wood take the same stain and the same topcoat. That is what makes the seam disappear.
Stain Matching Across Old and New Wood
Old wood and new wood do not take stain the same way, even when they are the same species. An existing floor that has aged for decades may have darkened or shifted in color, and a fresh board takes stain like a sponge. The result, without matching, is a visible patch of lighter or darker wood right where the wall used to be.
We handle this by testing stains on both the old and the new wood, finding a color that bridges the two so the floor reads as one. Sometimes that means a slightly darker stain that pulls the new boards toward the aged color of the old floor. Sometimes it means accepting a little variation and working with the natural character. We show you sample spots on the real floor before we commit. See our hardwood floor staining page for how we sample.
Transitions Where Materials Meet
An open concept remodel in Mableton is rarely one material from wall to wall. A kitchen may become LVP or tile while the living room stays hardwood, and the new open sightline means the transition between them is on display in a way it never was when a wall hid it. A transition that looked fine behind a wall can look awkward in an open space.
We plan transitions so the change from hardwood to LVP or tile reads as intentional and clean, handling any height difference between the materials and choosing transition pieces that fit the look. In an open concept space, the transition is part of the design, not just a practical seam. Our custom flooring page covers how we approach transitions.
Mid Century Ranch Floors Worth Keeping
Mableton's mid century ranch homes often have good bones, and the original hardwood in them is one of the features that makes them worth remodeling rather than replacing. A thoughtful open concept remodel keeps that original wood and makes it the thread that runs through the newly opened space. The alternative, ripping it out for a single new floor, throws away the character that makes a mid century ranch feel like a mid century ranch.
If you are planning an open concept remodel in Mableton, we can come out during the planning stage, before the walls come down, to look at the existing floors and talk through how the blend will work. Planning the flooring before the demolition is a lot easier than figuring out the blend after the wall is already gone.
How We Blend Floors for a Mableton Remodel
Blending floors after a wall removal is a custom job, and it works best when we plan it before the wall comes down.
- 1
Pre Demo Walkthrough
If possible, we come out before the wall comes out to look at the existing floors on both sides and plan how the blend will work.
- 2
Species and Cut Matching
We identify the existing wood species, cut, width, and grade so we can source new boards that match as closely as possible.
- 3
Lace In the New Boards
We cut back the existing floor and weave the new boards into the field so the joints stagger and the seam does not read as a line.
- 4
Sand and Stain to Blend
We sand the whole area to one surface and test stains on both old and new wood so the two sections take the same color.
- 5
Finish and Walkthrough
We apply a fresh finish across everything and walk the floor with you to confirm the blend reads as one continuous surface.
Is My Mableton Remodel a Blending Job?
If your Mableton remodel involves removing a wall between two rooms that both have hardwood, you have a blending job. The question is whether the two floors are the same species and close enough in age to blend well, or different enough that a full refinish of both sides plus careful stain matching is the way to go. We can tell you that after a look.
If one side has hardwood and the other has carpet or tile that you are replacing, the job is part installation and part blending, which is exactly what our custom flooring solutions cover. Either way, planning the flooring as part of the remodel, not as an afterthought, is what makes the finished space read as one open room.
Serving Mableton and the Surrounding Area
Based in Powder Springs, GA, we serve Mableton and homeowners across west, north and south metro Atlanta. We are available Monday to Saturday from 8:00 AM to 6:00 PM, and quotes are free. See the full list of towns we serve on our service areas page.

Mableton, GA
Residential hardwood floor care by Wala Hardwood Floors LLC.
Get Your Free Quote
Tell us about your residential flooring project. We respond promptly Monday to Saturday.
Hardwood Flooring in Mableton FAQ
Can you make the new hardwood blend with my existing Mableton floor after a wall comes out?
Yes. We match the species, cut, width, and grade, then lace the new boards into the existing field so the joints stagger. After sanding and finishing the whole area together with a stain that bridges the old and new wood, the seam reads as natural variation rather than a line across the floor.
Why does new wood look different from my old floor even when it is the same species?
Old wood has aged and often darkened, and it takes stain differently than fresh wood. A stain that looks right on a sample chip can look wrong on new boards next to an old floor. We test on both the old and new wood and choose a color that bridges them so the floor reads as one.
Should I call you before or after my Mableton open concept demolition?
Before, if possible. Looking at the floors on both sides of the wall before it comes out lets us plan the blend and source matching boards ahead of time. Planning the flooring before demolition is much easier than figuring out the blend after the wall is already gone.
What if one side of the removed wall is hardwood and the other is tile or LVP?
That is part installation and part blending, which is exactly what our custom flooring solutions cover. We install the new material where the old one was removed, then blend or transition it into the existing hardwood so the whole space reads as one open room.
How do you handle the height difference between hardwood and LVP in my open concept space?
Hardwood and LVP often sit at slightly different heights, and an open sightline puts that transition on display. We choose transition pieces that handle the height difference cleanly so the change reads as intentional rather than awkward. In an open space the transition is part of the design.
Are the original hardwood floors in Mableton ranch homes worth keeping?
Often yes. Mid century ranch homes in Mableton frequently have good original hardwood, and a thoughtful remodel keeps that wood and makes it the thread running through the opened space. Ripping it out for a single new floor throws away the character that makes a mid century ranch feel right.
Do I need to refinish the whole floor or just the repaired area?
Usually the whole floor. Sanding and finishing just the repaired area makes the new boards stand out against the old finish. Sanding and finishing the whole area together, with a stain that bridges old and new wood, is what makes the repair blend into the existing floor.
Most Relevant Services

Custom Flooring Solutions
Bespoke layouts, species transitions, board orientations, and custom threshold integration.

Sanding & Refinishing
Restore worn, scratched surfaces down to raw wood before staining and durable topcoating.

Hardwood Floor Staining
Custom on-floor stain sample consultations to achieve your ideal shade and tone.
Neighboring Communities
Opening Up Your Mableton Home? Blend the Floors Right.
When a wall comes out, the two floors have to become one. We blend new boards into existing hardwood so the seam disappears. Call for a free quote.
